21, Jalan MJ 14,
Taman Industri Meranti Jaya,
47100 Puchong,
Selangor, Malaysia.
+603-8066 2496
+6012-522 1357
+6012-522 1357
+603-8062 6172
XTS Technologies Sdn Bhd
21, Jalan MJ 14,
Taman Industri Meranti Jaya,
47100 Puchong,
Selangor, Malaysia.
21, Jalan MJ 14,
Taman Industri Meranti Jaya,
47100 Puchong,
Selangor, Malaysia.
PT Bachtera Ladju
(Indonesia Distributor)
Jl Tanah Abang III No.29
Jakarta, Indonesia.
+622129610745
sales-4@bachteraladju.com
(Indonesia Distributor)
Jl Tanah Abang III No.29
Jakarta, Indonesia.
+622129610745
sales-4@bachteraladju.com
PS-24 24VDC Power Supply
| Previous | 5 / 5 | Next |
- Maximum Momentary Output of 17A -
Up to 17A of maximum momentary output current is possible at 8.5A rated output current.
- Parallel Operation Enabled -
Up to 5 unites can be operated in parallel.
- Load Detection Function -
Load percentage can be detected by the RDY (Ready) display lamp.
Features
Maximum Momentary Output of 17A
While the rated output current is 8.5A, maximum momentary output current of up to 17A is supported. This lets you select an appropriate power-supply capacity based on the total rated current of actuators, without having to consider the maximum momentary current that may be generated by the actuator during acceleration.
Because you no longer need to use an expensive high-capacity power supply, cost can be reduced substantially.
* The maximum momentary output current must be considered if the actuator operating conditions are tight. For details, refer to "Selection Guide" on the right.
Up to 17A of maximum momentary output current is possible at 8.5A rated output current.
- Parallel Operation Enabled -
Up to 5 unites can be operated in parallel.
- Load Detection Function -
Load percentage can be detected by the RDY (Ready) display lamp.
Features
Maximum Momentary Output of 17A
While the rated output current is 8.5A, maximum momentary output current of up to 17A is supported. This lets you select an appropriate power-supply capacity based on the total rated current of actuators, without having to consider the maximum momentary current that may be generated by the actuator during acceleration.
Because you no longer need to use an expensive high-capacity power supply, cost can be reduced substantially.
* The maximum momentary output current must be considered if the actuator operating conditions are tight. For details, refer to "Selection Guide" on the right.